Skip to main content

Virtual Lab module · Star–Delta

Star–Delta Simulation for Motor Control Practice

A star–delta starter runs the motor in star at reduced voltage, then switches to delta after a timer delay. In Koniami Virtual Lab you wire the power and control circuits yourself, run the simulation, and see what happens before touching a physical panel.

Complements, and does not replace, practice with physical equipment.

Koniami Virtual Lab
Koniami Virtual Lab workspace showing a star–delta circuit with a 3-phase induction motor

What you practice

  • Wire three contactors (main, star, delta), a timer, and a 3-phase induction motor
  • Run the star-to-delta transition after the timer delay
  • Check the interlock between the star and delta contactors
  • Read the Overview, Guide, and Logic diagnostics

Wiring mistakes it can recognize

  • Star and delta close together

    If both contactors can energize at once, the supply is short-circuited. The Logic tab shows the path that proves it.

  • Timer not connected

    The transition to delta never happens because the delta contactor never gets coil voltage.

  • Phases swapped at the main contactor

    The motor runs in reverse; phase-sequence detection flags it.

Try it yourself in the browser, no installation

Book a Demo