Skip to main content

Virtual Lab module · DOL

DOL Circuit: Start–Stop Practice for a 3-Phase Motor

DOL is the most basic control circuit: one contactor runs a 3-phase motor directly at full voltage. Practice start/stop buttons, the self-holding (seal-in) path, and overload protection in the simulator before working on a panel.

Complements, and does not replace, practice with physical equipment.

Koniami Virtual Lab
Koniami Virtual Lab workspace (illustrative screenshot)
Illustrative workspace screenshot — this module’s own screenshot is coming.

What you practice

  • Wire a 3-phase supply, a contactor, and an induction motor
  • Build the self-holding (seal-in) path with start and stop buttons
  • Add a thermal overload relay (optional)
  • Watch the contactor and motor respond when the circuit runs

Wiring mistakes it can recognize

  • Two phases swapped at the output

    The motor runs in reverse. Forward and reverse phase sequences are recognized by the diagnostics.

  • Incomplete connections

    Wiring completeness is compared with the required connections, and what is missing is shown.

  • Supply short circuit

    This fault is flagged before you try it on real equipment.

Try it yourself in the browser, no installation

Book a Demo